Publicité
Les langues disponibles
Les langues disponibles
English
Keypad Security Settings
The keypad lock avoids undesired, potentially dangerous operations, which might be attempted when the
controller is operating in a public place. It can also prevent unauthorised adjustment of the cabinet temperature.
Press briefly '
' then use either '
' or '
'to change from a '
Cleaning and Maintenance
Important: Before cleaning, the unit should be put into standby and then the power supply should be turned off at
the mains. Please do not plug or unplug the unit with wet hands. Only when cleaning has been completed and the
unit is dry should the counter be turned back on at the mains.
Suitable P.P.E (Personnel Protective Equipment) should be worn at all times.
Regular Maintenance:
As and when required remove all product from the unit. Clean exterior and interior surfaces with mild liquid
>
detergent, following the directions on the pack at all times. Rinse surfaces with a damp cloth containing clean
water. Never use wire wool, scouring pads/powders or high alkaline cleaning agents i.e bleaches, acids and
chlorines as these may cause damage.
Bin Removal
>
Condenser Cleaning:
>
This should take place on a regular basis (4 to 6 weeks) or as and when required only by your supplier (this is
normally chargeable). Failure to maintain the condenser may invalidate the warranty of the condensing unit and
cause premature failure of the motor/compressor.
All gaskets should be inspected on a regular basis and replaced if damaged. To clean, wipe with a warm damp
>
soapy cloth followed by a clean damp cloth. Finally thoroughly dry.
Drawers and their bins should be removed to clean. All should be cleaned with warm soapy water then rinsed
>
and dried before refitting to the counter.
If fitted, the overshelf should be wiped down regularly with warm soapy water, rinsed and then dried as a
>
worktop would be.
If fitted, the can opener should be maintained as any other kitchen utensil, be aware of possible sharp parts
>
when carrying out maintenance on this part.
5
' or '
' to select '
' to '
'. Leave for 10 seconds or briefly press '
'. While holding '
' use either '
' to resume.
Publicité
