Publicité
Les langues disponibles
Les langues disponibles
1. INTRODUCTION
It is an inverter power source that can carry out the following welding modes:
M
MA
•
C
ONTINUOUS
•
P
T
welding with pulsed current at L
ULSED
IG
•
P
T
welding with pulsed current at M
ULSED
IG
•
T
A
with square wave
IG
C
•
In all types of TIG welding, it is possible to use the following welding processes:
Two-stroke lift-arc (2
•
Four-stroke lift-arc (4
•
Two-stroke H
•
Four-stroke H
•
Four-stroke H
•
The generator has:
A front control panel with socket for remote controls.
A rear panel with gas supply connector, switch and supply cable.
A positive (+) welding socket, a negative (-) welding socket, a gas supply connector and a torch connector on the
front part.
THE MACHINE CAN ALSO BE CONNECTED TO ENGINE-DRIVEN GENERATORS AS LONG AS THEY HAVE A
2. INSTALLATION
WARNING: This equipment does not comply with IEC 61000-3-12. If it is connected to a public low voltage system,
it is the responsibility of the installer or user of the equipment to ensure, by consultation with the distribution network
operator if necessary, that the equipment may be connected.
The generator in question must be supplied with a rated voltage of 1x230V~±15%/50-60Hz
Connect the generator to the mains supply and position the switch to the "I"/"ON" position, and the welding
machine will set itself into the last welding process used.
Using the front panel, choose the new welding process.
3. REAR PANEL.
All manuals and user guides at all-guides.com
GALA ELECTRONICS 200 ACDC
T
IG
) (Only TIG DC)
T
) (Only TIG DC)
T
(2
H
)
F
T
F
(4
H
)
F
T
F
Bi-level (B
)
F
ILEVEL
STABILIZED VOLTAGE.
frequency (slow pulsed TIG)
OW
frequency (fast pulsed TIG)
EDIUM
C1:Supply cable 3x2,5mm² with a length of
•
2,5m.
A1:Rear gas connector. It is used to connect
•
the gas pipe coming from the gas bottle.
I1: Supply switch. It is the switch to turn on the
•
machine. It has two positions, "I" and "O". When the
machine is connected to the mains with I1 in the "I"
position and in the MMA mode there is power between
the negative and positive clamps.
Z1: Connector to power the cooling unit. If it
•
is not connected, continue to keep it closed with the cover
because there is an alternating 380V voltage!
10
.
Publicité
