Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

If you start the camera for the very first time the search process can take up 3
minutes and more. If you switch the camera on after a long time it will take
about 1 to 1.5 minutes for the search process to finish. And if you have recently
recorded it will only take a few seconds.
4. Power OFF: Keep the power button pressed for about 3 seconds. You will hear
a short beep followed by a long beep and then the camera will shut down

5.2 Indoor

When you want to take a video indoors the camera won´t be able to find any GPS
signal and will keep on searching (Outdoor Step 3). In this case you have to shortly
press the Power On/Off button again. You will hear one long beep followed by two
short beeps which indicate the start of a recording.
Please Note
1. If you use indoor recording the recorded video will playback but without the
GPS map.
2. When the product catches a GPS signal, it will switch to the GPS recording
mode.
3. If the memory card is almost out of memory the camera will beep shortly three
times. This will be repeated every two minutes for the final 10 minutes.
4. The same warning will appear for when the camera is low on battery. It will
beep every two minutes until the batteries are below 2V this will shut down the
camera immediately.
8

Publicité

Table des Matières
loading

Table des Matières