Inepro SunTimer 2400 Manuel D'instructions page 12

Settings
Function P0, Output configuration
By means of this function the relay output can be defined. It is possible to choose between;
- A signal output, which is active throughout the whole session.
- A pulse output which is briefly active/generating a pulse in the beginning of the main time and in
the beginning of the post time.
For more details, see "table of connections".
Setting "00": Signal output
Setting "01": Pulse output
Signal output
Relay 1
Relay 2
Pulse output
Relay 1
Relay 2
End of prior time
Start of main time
Start of prior time
Function P1, External drive facility (as for example a PC.)
Setting "00": The SunTimer
either be internal or external by means of a "long distance board".
Setting "01": The SunTimer
main time. The prior time and the post time have to be programmed in the SunTimer
®
(F1) of the SunTimer has to be programmed according to the maximum length of time the connected
device may be activated. As soon as the external device is switched the prior time is automatically
activated in the SunTimer
disconnecting the external device the post time programmed in the SunTimer
activated.
Function P3, Display indication
Display indication, choice between 00 of --.
Setting "00": display during stand by one point (.), during the prior time, main time and post time two
hyphens will be displayed (--).
Setting "01": display indication in minutes
Function P4, Reduction of the main time
Setting "00": The reduction of the main time during the prior time is impossible
Setting "01": The reduction of the main time during the prior time is possible
®
is started by pressing the Timer key. The installation of this key can
®
is started via the presence of an external device. This device defines the
®
. After the prior time the SunTimer
®
SunTimer 2400 Version 3.0 25-01-2008
- www.inepro.com
End of main
time
®
passes on to the main time. After
-
End of post
ti
®
. The main time
®
is automatically
12