Publicité
Les langues disponibles
Les langues disponibles
3.4 TELRC infrared beam receiver
Remote adjustment of the control panel settings can
be carried out via the TEL2 radio remote control, by
installing the TELRC receiver inside the COME function
selector as shown in the TELRC receiver handbook.
4. Operation
After having connected the COME function selector and
the control panels, turn on all control panels together
and wait 30 s.
Operating modes
Mono-directional
Mono-directional opposite side
(flashing LED)
Bi-directional
Partial opening
(Only for mono-directional and bi-directional).
NOTE: if the automation has 2 swinging
wings, it allows 1 wing opening only.
Sliding door open
Swing door open
Delayed night locking (STOP)
Start the sequence: bi-directional (10 s with
J1= ON; 60 s with J1= OFF)
(max 60 s)
STOP.
Immediate night locking (STOP)
Sliding door closed
Swing door closed
Opening command
POWER RESET
Deletes all data learned by the control
panel.
Code setting (J3= ON)
NOTE: the code has a maximum of 5 digits.
During the setting operation the red led
flashes.
Code erasing (J3= ON)
NOTE: during the erasing operation the
red led flashes.
NOTE: see important information on the last page.
Selector without
access code
1
Key 1
1
Key 1
3 s
2
Key 2
3
Key 3
4
Key 4
4
Key 4
5
Key 5
door closed
Key 5
5
3 s
Key 6
6
6
Key 6
Key
1
Key 1
Key
3 s
Key
3 s
7
During the initial learning phase the key red led
flashes and the 1-2-3-4 green leds light up depending
on the number of control panels networked. If there are
two COME function selectors networked the 6 green
led lights up. Operating modes are shown in the table.
Selector with access code
CODE
CODE
CODE
CODE
CODE
CODE
CODE
CODE
CODE
CODE
Key
+ any key
5
CODE
+ key 5
CODE
key
CODE
key
1
key 1
1
key 1
3 s
2
key 2
3
key 3
4
key 4
4
key 4
5
key 5
5
key 5
3 s
6
key 6
6
key 6
+ CODE
1
key 1
+ key 5
3 s
3 s
5
Publicité
