Inside Antenna Installation; Powering Up The Signal Booster - WILSON PRO A500 Mode D'emploi

Antenna and Inside Antenna at the
designated ports.
3. Do NOT connect the Signal Booster
to the power source until all cables
are connected.

Inside Antenna Installation

1. Select a location in the center of
the area where you want cellular
signals improved to mount the Inside
Antenna. If you have multiple rooms
with poor signal, you may need
multiple Inside Antennas. These can
attach to the Signal Booster by using
a splitter (sold separately). Contact
Tech Support for more information.
2. Ensure a minimum of 6 vertical
meters or 15 horizontal meters
separation from the Outside Antenna.
Outside Directional
Antenna
Place the inside antenna
directly beneath the
placement of the Outside
Antenna location
At least 6.096m of vertical
or 15.240m horizontal
separation
Inside Panel Antenna
3. Inside Antennas can be mounted
above ceiling drywall, on a ceiling
inside a room, or on a wall inside a
room. Ensure the Inside Antenna
is facing AWAY from the Outside
Antenna to avoid oscillation
(feedback).
Face inside
antenna
away from
the outside
antenna.
Outside
Antenna
6
4.
Powering Up The Signal
Booster
1.
2.
3.
Troubleshooting
The WilsonPro A500-3G/4G has advanced
programming, allowing it to automatically
adjust for a variety of possible problems,
and still boost your signal. It also includes
three indicator lights, one for each band
(see FAQ for explanation of MHz bands).
All indicator lights will be green, red, or
orange; or a combination of these lights.
Inside
Antenna
Need help? support@techlineglobal.com
Use the mounting hardware included
in the package to secure the Inside
Antenna to the selected location.
Ensure the cables to both the Outside
Antenna and Inside Antenna are
securely connected before powering
up the Signal Booster.
Plug the power supply into the Signal
Booster input marked "POWER" and
then into a surge protector power strip
with a minimum 1000 Joule rating.
!
If your WilsonPro A500-3G/4G is
working working to it's full potential,
the lights will be solid green. If
the lights are not solid green, see
troubleshooting section.
Solid Green indicates the unit is
powered and working properly. You
always want the lights to be solid
green.
Blinking Red or Blinking Green and
Red indicates the WilsonPro A500-
3G/4G has reduced power, to prevent
oscillation (feedback).
Blinking Orange or Blinking Green
and Orange indicates the WilsonPro
A500-3G/4G has reduced power,