Publicité
Les langues disponibles
Les langues disponibles
CHARGING
Before first use, charge the product for 4 hours.
The window vacuum needs to be charged for 4 hours for 30 minutes of continuous use.
How to charge:
1. Connect the lead from the charger to the charging port (11) on the window vac.
2. Plug the charger into the mains. During charging the indicator (10) will light red. When the
window vac is fully charged, the indicator will light green.
3. Remove the charger from the mains and the connector from the window vac.
Note: If the indicator is flashing, the window vac is not charging, press the power button (8) to
reset the window vac.
USE
1. Wipe the front edge of the squeegee (1) to remove any impurities.
2. Remove the clean water tank cap (3) and fill the tank with water using the water jug. Make
sure not to overfill. You can add a small amount of window cleaning solution.
3. Pull trigger (9) to spray the solution on a window and wipe any excess dirt with the cloth.
4. Turn the window vac on by pressing the power button (8).
5. Move the window vac vertically from the top to the bottom of the window, until the window is
clean.
6. Hold the window vac at the bottom of the window to suck any excess dirty water.
7. Turn the window vac off when the dirty water tank (12) is full.
8. Open the dirty water tank cap (6) and pour the content away.
Note: Always unplug the window vac from the charger before assembly, cleaning or
maintenance.
CLEANING AND MAINTENANCE
• Do not immerse the main body in water.
• Always unplug the window vac from the charger before cleaning or maintenance.
• Wash the microfibre cloth in warm soapy water and let it dry properly.
• To clean the exterior of the window vac, wipe it with a soft damp cloth and then let it dry
properly.
• Clean the squeegee vacuum head and spray head in warm soapy water and let it dry.
4
Publicité
