Milwaukee 48-22-8536 Manuel De L'utilisateur page 5

BB
CC
Installing the Chest onto the Cabinet
Two people may be required to
CAUTION
complete installation.
1. Place the top chest on top of the rolling cabinet.
NOTE: The holes in the cabinet are tapped and do
not require nuts.
2. Attach the two brackets to the back of the product
to secure the top chest to the rolling cabinet. Place
the brackets over the holes and secure with four
screws (DD) per bracket.
3. Tighten all screws securely with a Phillips screw-
driver.
EE
Installing the Drawer Liners and Mat
Place the drawer liners in appropriately sized draw-
ers and the mat in the chest lid area to protect the
surface.
Installing the Corner Extrusions
and Bumpers
Place the front bumpers on both ends of the extrusion
by sliding the extrusion into the cavity of the bumpers.
Attach the front bumpers with extrusions using two
screws (EE) per bumper.
Attach the two rear bumpers to the back of the lower
cabinet using two screws (EE) per bumper.
EE
Installing the Cord Storage Brackets
Attach the brackets to the chest and cabinet with
two screws (DD) per bracket. Orient the brackets
with one pointed up and one pointed down so that
the power outlet cord can be wrapped around the
brackets for storage.
Installing the Bottle Opener
Attach the bottle opener to the left side of the cabinet
using two screws (FF).
Installing the Power Cord
Locate the power cord inside one of the right-hand
drawers. Untie the power cord and gently pull the
cord plug through the grommet.
OPERATION
To avoid injury or property damage,
WARNING
do not exceed maximum shelf ca-
pacity. Use care when moving chest/cabinet on
incline or rough surface. Chest/cabinet may tip
if weight is not evenly distributed front to back
and side to side. Place more than half the total
load weight on the bottom cabinet when possible.
Locking and Unlocking the Chest/Cabinet
NOTE: The drawers must be fully closed before
locking/unlocking the unit.
Insert the key. Turn it fully left to lock, or fully right
to unlock. Always remove the key after locking and
unlocking.
Using the Caster Brakes
To lock the swivel casters, step
down on the levers marked
ON. Be sure to lock both
casters to prevent chest/
cabinet from rolling or swivel-
ing. To unlock casters, push
down on the levers marked
OFF.
5