QEO FMR 800-M/C Mode D'emploi page 27

OPERATION
Power On/Off
ACCURACY SELECTION - HEIGHT INDICATION (ALL MODES)
RADIO TRANSMISSION (FMR 800-M/C and remote display FRD 807)
POWER ON
Press the „On / Off" button to power on.
All LED's will flash in sequence.
The receiver is now ready to use.
POWER OFF
Press and hold the „On / Off" button until the
LED's light up briefly to turn the device off.
The Accuracy LED displays the current setting.
The accuracy default setting after power-on is
standard.
fine standard
±5 mm ±15 mm
Press the accuracy button to change.
The „radio transmission" LED indicates the
selected channel.
Channel 1 Channel 2
Press the „radio transmission" button to acti-
vate channel 1.
Holding the „radio transmission" button down
longer changes the channel.
Press the „radio transmission" again to turn off
the radio transmission.
The remote display FRD 807 and the machine
receiver FMR 800-M / C must be set to the
same channel.
EN
E
coarse
±30 mm
Channel 3
27