User Manual; Assembly Of Upper Part And Base; Assembly And Replacement Of Springs; Brake - Vela Meywalk 2000 Large Manuel De L'utilisation

2.0. USER MANUAL

2.0.1. ASSEMBLY OF UPPER PART AND BASE

The upper part is placed in the risers on the chassis. The upper
part is lowered into place in the two risers.
Note: The handle must face the swivel front wheels.

2.0.2. ASSEMBLY AND REPLACEMENT OF SPRINGS

The first time the gait trainer is assembled, the supplied springs
must be fitted. Tilt the tilt bar and lift off the upper part. Put the
springs into the risers on the chassis - one on each side. Place
the upper part onto the chassis and lower it into place.

2.0.3. BRAKE

The brake rods are located in front of the rear wheels. Move
both brake rods backwards to activate the brake function on
both sides. The brakes are deactivated by moving both brake
rods forward again. Note: The brake must always be locked
when getting in and out of the gait trainer.

2.0.4. BRAKE ADJUSTMENT

Move the brake rods forward and loosen the two nuts that
attach the brake to the chassis. The brake mechanism can then
be adjusted back and forth. There must be 3-5 mm clearance
between the brake fitting and the cover. Remember to tighten
the nuts again. Note: do not adjust the brakes while the gait
trainer is in use.
1 2