OZ Lifting Products AS1418.2 Manuel De L'opérateur page 10

Lifting the Load
1. Place selector in the load (Up) position.
2. In this position the brake is engaged as lever stops in order to support the load.
3. Manually ratchet the lever in a clockwise rotation to lift the load.
4. Begin slowly in order to verify load is correctly seated and hoist is functioning properly.
Pre-load Requirements
WLL 3/4 ton. 77 lbs.
WLL 1 1/2 ton. 84 lbs.
WLL 3 ton. 110 lbs.
WLL 6 ton. 121 lbs.
WLL 9 ton. 172 lbs.
Lowering the Load
1. Place the selector in the unload (Down) position.
2. In this position the brake is engaged as lever stops in order to support the load.
3. Manually ratchet the lever in a clockwise rotation to lower the load.
Overload Protection
Overload protection comes standard on all OZ Lifting hoists and is factory calibrated. The overload
protection is integral with the hoist and prevents the operator from overloading the hoist. When activated,
the overload will not allow hoist operation.
Activation of overload protection:
• While lifting- Load should be lowered
• While pulling- Load should be released
• Indicates that a larger capacity hoist should be selected, or the lifting specialist should be
consulted for another means of operation.
EN pg.10