Marshalltown PTC48 Mode D'emploi page 6

To cut an angle:
1. Adjust angle guide to desired angle and place the
guide against the tile.
3. Flip the breaker down and position slightly away
from the front edge of the tile.
1. Adjust the Hex Bolts & Nuts on the Sliding Block as desired to modify sliding pressure. Ensure both the left
and right sides are adjusted equally.
2. Before storage, lubricate the rail on the cutter with a few drops of light oil to prevent rust.
3. Replace the scoring wheel when cutting becomes difficult or the score line is not clean. This is a standard
wear part.
6 of 8
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com
2. Carefully lower wheel until it makes contact with
tile and then apply consistent pressure while
scoring full length of the tile.
4. Apply increasing downward pressure on handle
until the tile snaps.
NOTES
WS2771