Safe Operating Practices - NewAge Products 65902 Mode D'emploi

Safe Operating Practices

• Newage Double Burner must be assembled and installed according to the instructions in the manual.
• Read the entire instruction manual prior to operating the double burner.
• NewAge Double Burner must be used outdoors in a well ventilated area, and cannot be used indoors, in
a enclosed area such as a garage, gazebo, screened in porch or other similar enclosed area.
• The NewAge Double Burner cannot be installed in or on a recreational vehicle, or boats.
• Face the front of the burner towards the prevailing wind. High winds can cause flame blowouts.
• Do not modify the NewAge Double Burner.
• Do not operate the NewAge Double Burner under, or near combustible construction.
• Maintain proper clearance to combustibles,18" (457mm) to rear of unit, 10" (254mm) to sides and
40"(1016) from overhead structure. Additional clearance of 32" (810mm) is recommended near vinyl
siding or panes of glass.
• When not in use turn off the gas at the supply valve.
• If using a L.P cylinder (propane tank) always shut off the main valve on the L.P. cylinder after each use.
• Never use dented, rusty or damaged propane cylinders.
• A spare LP propane tank cannot be stored below the gas grill, burner or in a cabinet.
• Never attach or disconnect an LP cylinder, or move or alter gas fittings when the burner is in operation or
is hot.
• Use only propane cylinders with a QCC1 type connection.
• When the propane cylinder is connected to the appliance, the gas burner and cylinder must be stored
outdoors in a well-ventilated space.
• When the gas burner is to be stored indoors, the connection between the propane cylinder and the gas
burner must be disconnected and the cylinder removed and stored outdoors in a well ventilated space
out of reach of children. Disconnected cylinders must not be stored in a building, garage or any other
enclosed area.
• Natural gas units must be disconnected from the supply when being stored indoors.
• Inspect the fuel supply hose before each use. If there is evidence of excessive abrasion or wear or the
hose is cut, it must be replaced prior to using the gas grill with a replacement hose assembly specified by
the grill manufacturer.
• Leak test the unit before initial use, annually, and whenever any gas components are replaced.
• Use only a Ground Fault Interrupter (GFI) protected circuit with this outdoor cooking gas appliance.
• Follow lighting instructions carefully when operating grill.
24
www.newageproducts.com