MediaShop iWalk Mode D'emploi page 12

SUGGESTIONS
• Always wear clean sports shoes to prevent contamination of the belt.
• Use a damp cloth to clean the outside of the belt.
• Fold the treadmill together and wipe or vacuum the surfaces. This will prevent dust from entering the unit and causing it
to malfunction.
• Before cleaning / servicing the unit, make sure it is switched off and disconnected from the power supply.
• Do not use solvents to clean the device.
• Remove stubborn, oily, greasy stains or other dirt from your treadmill with a mild detergent and cotton cloth. Finally,
remove excess detergent with a dry cloth.
• Do not use any liquids or cleaning agents on the control panel, only a dry cloth.
• Do not immerse any of the parts of the device in liquid detergents.
OPERATING THE COMPUTER (FIG. 4):
The display offers you a selection of functions that allow optimal use of the device and the programs.
On / Off: Turning the device on and off.
Mode: Program Selection, Timing Data display on screen while you're training: speed, time, distance, and
calories burned
Speed +/ -: Allows you to set the treadmill speed. The speed range is between 1.0 and 10 km/h.
Explorer: is used to determine the amount of time already traveled, distance, and calories burned.
LED Speed Indicator: Indicates the speed of your workout.
LED Time Display: Indicates the elapsed training time.
LED Distance Display: Displays the distance covered.
LED Calorie Indicator: Shows calories burned.
Music feature: 3.5mm audio cable - audio input.
IMPORTANT: For safe handling, use a grounded circuit. Grounding reduces the risk of electric shock. The
equipment must be connected to a grounded electrical outlet that complies with local safety guidelines and
standards. As soon as you connect the device to the power, the LEDs light up and you hear 5 beeps. This
indicates that the device is in standby mode. The display shows: „= = =".
TROUBLE SHOOTING:
Problem
The device does not turn on / does
not work.
The device does not turn on / does
not work.
The device does not turn on / does
not work.
The device does not turn on / does
not work.
HOW TO FOLD THE TREADMILL: (FIG.5-7)
1. Turn the locking bolt counter clockwise.
2. Lift the lower part of the device.
3. Pull out the fixing knob and place it in the hole of the main supports.
4. Now you can slide your treadmill by holding the handles with both hands and lowering so that the wheels
touch the ground.
12
Possible reason
The device is not connected to the
power.
The device is switched off
The voltage is too low.
The emergency button is not
attached.
Solution
Connect the device to the power
supply.
Press the ON / OFF button.
Wait for the power to work
properly again.
Attach the emergency button to
the magnetic part of the computer.