CAME MI6030 Mode D'emploi page 38

Our MI antipanic breakthrough series have been designed to be applied even on
sliding doors built with any type of adequately adapted commercial series.To this
purpose, the following pages contain the necessary measurements and/or notes
to plan and resize the doors.
Preliminary Notes:
WALL-TYPE FRAMES:
- They must be able to contain the hinging corners (pg. 14/15);
- Machining and thickening must be performed according to the best functional lodging of the
hinges;
- It is important to set adequate passages for the "CLOSED DOORS" sensor connections and
photoelectric cells.
FIXED AND MOBILE DOORS
- The preparation of the doorframes must allow the insertion of the hinge pins; it is
recommended that the faced and fixed cross members be mounted with U-bolts;
- Pay attention to how the hinge elements are attached to the structure. They should be fixed
rigidly in order to avoid that with time vibrations and movement limit efficiency and make the
system unsafe for users;
- If the structure is not strong enough, the assembler must reinforce it.
- Upper and lower hinges must be aligned axially.
- Only in case of mobile doors, it is recommended that the glass be firmly set with silicone
sealant in addition to any other types of weather strip.
- Only stratified or tempered glass should be used.
MACHINING SEQUENCE
FRAME
- Follow directions on page 14 for wall-type frame machining and assembly. Pay particular
attention to hinge axle alignment.
- It is possible to make both vertical and horizontal adjustments for the alignment of the fixed
door by turning the adjustment screws.
- Ensure adequate passages for the "closed doors" magnetic sensor cables and for the
photoelectric cells.
FIXED DOORS
- Resize the doors according to the dimensions and the useful characteristics referring to the
notes on sizes in pages 12/13.
- Carry out work for the housing of hinging devices as indicated in pages 15/16; prepare housings
for any photoelectric cells.
- Assemble the devices indicated, making sure the hinges and spring latches are aligned axially.
- Insert the fixed doors in the hinge supports, working with a screwdriver for the insertion of the
upper pin (pg. 15); align the doors and set the adjustments of the hinges.
- Align the closing blocks (PM306) to the closing spring latches in the "closed doors" position
and fasten the blocks to the upper frame and to the ground (pg. 16).
- Align and lock the "closed doors" magnetic contacts.
- pg. 10 -
COMMERCIAL SERIES mounting instructions COMMERCIAL SERIES mounting instructions COMMERCIAL SERIES mounting instructions
COMMERCIAL SERIES mounting instructions COMMERCIAL SERIES mounting instructions
MAKE SURE THE BREAKTHROUGH SIDE IS CORRECT!