Publicité
Use your GeoSafari
®
SeaScope
®
Explore a pond, stream, lake, tide pool, or even a swimming pool. You can
even stay dry while you explore underwater. Just submerge the end of your
SeaScope in the water while on land or in a boat. Make sure an adult is with you.
Do not explore alone!
Let's Explore Your SeaScope
Eyepiece
Focusing tube
Center tube slides
inside for easy carrying
Before using your SeaScope for the first time, insert 3 AAA batteries
into the battery compartment, following the instructions at the end of this guide.
Pull the center tube out of the main body until it clicks into place. Insert the end
of the SeaScope into the water. Look through the eyepiece. Focus by sliding the
focusing tube in and out. If you need more light in order to see, press the power
button to turn on the light.
Because the lens magnifies the image five times, it is hard to know a specimen's
size. Use the ruler on your SeaScope to find out how big your specimens
actually are. Record your findings. Also, note the temperature on the
SeaScope thermometer and record it. Different living things thrive at different
temperatures.
The surrounding temperature is highlighted on the SeaScope thermometer. If
a temperature is clearly highlighted in green, that is the temperature. If more
than one temperature is highlighted, the exact temperature is in between the
highlighted numbers.
to explore the awesome underwater world.
Attachment ring
Caution: SeaScope floats. Hold your SeaScope firmly when placing it in water.
If you let go, it will pop out of the water and may cause injury.
You can use the SeaScope without the 5x magnification. Unscrew the center
tube from the main body. View your object through only the main body. This will
give you a wider field of view. Because you are looking at the object through
both water and air, the image will still be naturally magnified. Try observing both
with and without the 5x magnification to see the difference.
Power button
Ruler
for light
Main body
Caring for Your SeaScope
The SeaScope main body is water resistant, but water, dirt, or sand may
accidentally get inside. If this happens, clean and dry the unit as soon as
possible. To clean, separate all three tubes. Pull firmly on the focusing tube to
remove it from the center tube. Turn the attachment ring counterclockwise to
loosen the ring. Then pull firmly on the center tube to remove it from the main
body. Rinse the inside of the tubes with fresh water. Use a towel to dry all parts.
If using in salt water (such as the ocean), always rinse in fresh water after use in
order to remove the salt.
Thermometer
(on reverse)
Battery
door screw
LED lights
Publicité
