Télécharger Imprimer la page

BEHA PB Manuel page 9

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 14
USE OF THE HEATER
After the heater is installed and plugged in to the wall power outlet, switch on the on/off switch and leave it on
for at least 15 minutes without opening the Bluetooth app. The electronic thermostat will go into auto
calibration mode and create a temperature profile based on the wattage of the heater. The white light will be
blinking until the heater is ready.
The light in the thermostat wheel will be lit when the heater element is connected. When the set temperature is
reached the light will be turned off.
The temperature range is 5 C to 30 C.
TECHNICAL INFORMATION
By power outage:
Without app:
The heater returns to chosen temperature.
Cold draft/Open window function:
When opening a window and the temperature drops more than 5°C within 40 sec the cold draft function is
activated. The heater changes between chosen temperature for 10 seconds, and 5 degrees for 30 seconds. The
function is active for max. 15 minutes.
BEHA heaters PB and LB are IP24 tested and approved for installation in bathrooms and utility rooms.
This apparatus is in compliance with the following EU
directive:
2014/30/EU (EMC) electromagnetic noise
2014/35/EU (LVD)
2011/65/EU (ROHS) use of dangerous substances
The product must be treated in compliance with EU
directive 2012/19/EU. The apparatus must not be disposed
of together with regular house waste but be handled to an
approved waste dump for separation and recovery station.
A defect product must be treated correctly, in order to
prevent health or environment risks.
Information about energy consumption:
The product complies with the EU regulations on the
Ecodesign Directive (2009/125/EC) for energy-related
products (ErP).
o
o
BEHA ELEKTRO AS, 3940 PORSGRUNN
Tlf:. 35 51 62 50 Ordre: 35 51 62 70
e-post: post@beha.no
www.beha.no
The symbol
documents accompanying the product, indicates
that this product may not be treated as household
waste. Handing it over to a authorized for the
recycling of electrical and electronic equipment.
Pick must be in accordance. The local waste
regulations. For further information treatment,
recovery and recycling of this product, contact
your local council, waste disposal service or the
shop where you purchased it.
9
on the product or on the
GB

Publicité

loading

Ce manuel est également adapté pour:

LbPgbLgb