Error List - Ariston NIMBUS M NET Mode D'emploi Pour L'utilisateur

4.2

Error list

The errors are displayed on the interface in the indoor unit (see paragraph "System interface SENSYS HD").
Indoor unit errors
Code Description
114 Outdoor sensor not available
730 Buffer high probe error
731 Buffer overtemperature
732 Buffer low probe error
902 System flow sensor damaged
923 Heating circuit pressure error
924 HP communication error
927 AUX inputs correspondence error
928 Energy supply shutdown
configuration error
933 Flow sensor overtemperature
934 DHW tank sensor damaged
935 Tank overtemperature
30 / EN
Temperature control activation based on the external sensor
External sensor not connected or damaged. Check the sensor's connection
and replace it, if necessary.
Buffer filling inhibited. Check the hydraulic diagram.
Buffer sensor not connected or damaged. Check the sensor's connection and
replace it, if necessary.
Buffer filling inhibited. Check the hydraulic diagram.
Buffer sensor not connected or damaged. Check the sensor's connection and
replace it, if necessary.
Buffer filling inhibited. Check the hydraulic diagram.
Buffer sensor not connected or damaged. Check the sensor's connection and
replace it, if necessary.
Delivery sensor not connected or defective. Check the sensor's connection
and replace it, if necessary.
Check for any water leakages in the hydraulic circuit
Faulty pressure switch
Defective cabling of the pressure switch. Check the connection of the
pressure switch and replace it, if necessary.
Check the cabling between the TDM board and the Energy Manager
Verify the configuration of parameters 1.1.3 and 1.1.4
Check the configuration of parameter 1.1.5
Check the flow in the primary circuit. Delivery sensor not connected or
defective. Check the sensor's connection and replace it, if necessary.
Calorifier sensor not connected or defective. Check the sensor's connection
and replace it, if necessary.
Check whether the 3-way valve is locked in the DHW position. Check the
connection of the calorifier's sensor and replace it, if necessary.
Resolution
Initial start-up