JVC DLA-RS67 Instructions page 20

Precautions during Mounting
Securing (mounting) the projector
.
When this unit is to be mounted to a fixed position for
0
use, install it horizontally.
Make sure to secure the main unit to prevent
0
accidents such as during an earthquake.
Securing with screws
Air Inlets
.
Remove the four feet at the bottom, and fasten using the
screws (M5 screws, 13 to 23 mm).
* Using screws other than those designated may cause
the unit to break down.
* Leave a clearance of at least 10 mm from the bottom
surface of the unit to allow it to take in cool air.
20
4 Locations
Securing the projector (ceiling mount)
.
Be sure to ask your dealer to install the unit for you.
0
Installing the unit on your own may cause the unit to
fall resulting in injury.
Take the necessary actions to prevent the main unit
0
from falling off such as during an earthquake.
Regardless of the warranty period, JVC is not liable
0
for any product damage caused by mounting the unit
with non-JVC ceiling fittings or to an environment that
is not suited for ceiling mount.
When using the unit with it suspended from a ceiling,
0
pay attention to the surrounding temperature. When
a heater is in use, the temperature around the ceiling
may be higher than expected.
To attach the unit to the ceiling mount bracket, set the
0
torque between the range of 1.5N m to 2.0N m.
Tightening with torque exceeding the above range
may cause damage to the unit, which may result the
unit to fall.