PRO-POINT 8678963 Mode D'emploi page 8

8678963
4. Prevent damage to the power cord by observing
the following:
4.1 Do not pull on the cord to disconnect the plug from
an outlet.
4.2 Keep cord away from heat, oil, sharp edges or
moving parts.
4.3 Never use the cord to carry the tool.
5. Do not allow people, mobile equipment or vehicles to pass
over unprotected power cords.
5.1 Position power cords away from traffic areas.
5.2 Place cords in reinforced conduits.
5.3 Place planks on either side of the power cord to create
a protective trench.
6. Do not wrap cord around the tool as sharp edges may cut
insulation or cause cracks if wound too tight. Gently coil
cord and either hang on a hook or fasten with a device to
keep cord together during storage.
UNPACKING
WARNING! Do not operate the tool if any part is missing.
Replace the missing part before operating. Failure to do so
could result in a malfunction and personal injury.
Remove the parts and accessories from the packaging and inspect
for damage. Make sure that all items in the parts list are included.
Contents:
• Spindle Sander
• Sanding Sleeves (1/2, 3/4, 1, 1-1/2, 2 and 3 in.)
• Rubber Sanding Drums (3/4, 1, 1-1/2, 2 and 3 in.)
• Table Inserts (1/2, 3/4, 1, 1-1/2, 2 and 3 in.)
• Bottom Spindle Washer (2-3/4 in.)
• Upper Spindle Washers (5/8, 7/8 and 1-3/4 in.)
• Spindle Lock Nut
• Wrench
8
SPINDLE SANDER
For technical questions call 1-800-665-8685
V1.0