Gemini 1D002554 Mode D'emploi page 11

13. CUSTOMIZATION PROCEDURE
This procedure requires the use of an associated operating remote control.
To enter in programming mode, disarm the alarm and turn ignition key ON. The LED will light up for 1 sec.; while the
LED is ON, simultaneously press remote control BUTTONS 1 and 2. The LED will turn ON steady and 2 Bops will
confirm the system has entered in programming mode.
Through BUTTONS 1 and 2 select the desired programmable function:
1) Function configuration (BUTTON 1 followed by BUTTON 1).
2) PIN code customization (BUTTON 1 followed by BUTTON 2).
3) Tilt sensor sensitivity adjustment (BUTTON 2 followed by BUTTON 2).
4) Learning new remote controls (BUTTON 2 followed by BUTTON 1).
If no option is selected within 8 sec., the system automatically exits the procedure with 2 Bops and 1 Beep and the
LED powers OFF.
1) Function configuration:
Press remote control BUTTON 1 (1 confirmation Beep), then BUTTON 1 again (1 confirmation Beep), the LED stays
ON steady during the entire procedure. Two Beeps will acknowledge the system has entered in programming mode.
N.B.: BUTTON 1 will enable the function while BUTTON 2 will disable it; in both cases the system moves to the next
function.
Acoustic signals
Passive arming
Pre‐alarm
Self‐rearming
Not used
Press BUTTON 2
When the last function has been enabled or disabled, the system automatically exits the programming procedure; 2
Bops and 1 Beep will confirm the end of the procedure and the LED will power OFF. Turn ignition key OFF.
You can exit the programming procedure at any time by turning ignition key OFF. Programmed functions will
automatically be saved while the others will remain unvaried.
Acoustic signals:
The alarm system confirms the execution of the arming/disarming operations through acoustic signals (Beeps).
Acoustic confirmation tones are factory enabled.
Passive arming:
If enabled, the system automatically arms every time ignition is switched OFF making sure the vehicle is not be left
unprotected. When ignition is switched OFF the turn indicators flash once, the LED twice and the siren Beeps twice to signal
the 35 sec. passive arming countdown. After 35 sec. a flash of the turn indicators and 2 Beeps will confirm the system is fully
armed. The LED will also power ON steady.
Turning ignition ON during the 35 sec. countdown will interrupt passive arming. If the seat/topcase input (Green‐Brown
wire) is connected to a positive feed, the procedure is also interrupted; it will resume once the wire is disconnected.
Pre‐alarm (warning alarm):
If enabled,the siren during an alarm condition (ex. tilt) will sound for approx. 2.5 sec. for the first 3 alarm events,
then, from the 4th event on, it will sound for 25 sec.. Alarm cycles will be reset every time the alarm is disarmed or
whenever the panic alarm is triggered.
Self‐rearming:
If enabled, the system, when armed and then accidentally disarmed, will automatically rearm 35 sec. after it
has been unintentionallly disarmed.
FUNCTION
SELECTABLE FUNCTIONS DESCRIPTION
DEFAULT
BUTTON 1
SETTING
ENABLED TO ENABLE
DISABLED TO ENABLE
DISABLED TO ENABLE
DISABLED TO ENABLE
‐‐‐ ‐‐‐
BUTTON 2
TO DISABLE
TO DISABLE
TO DISABLE
TO DISABLE
‐‐‐
11/39