EarthQuake IG800W Manuel De L'utilisateur Et Instructions D'utilisation page 17

AIR FILTER
Maintaining an air filter cleaner in proper condition is very im-
portant. Dirt induced through improperly installed, improperly
serviced or inadequate filters damages and wears out engines.
Keep the filter clean.
Cleaning / Replacing Air Filter:
1. Remove the side panel on the starter handle side of the gen-
erator by loosening the four screws holding it in place.
SEE FIGURE 8
2. Remove the air filter cover by loosening the one screw hold-
ing it in place and then remove the air filter.
3. Replace with a new oiled filter, or wash the current filter with
warm water and mild soap. Remember to thoroughly oil the
foam filter with 30 or 40 weight motor oil and squeeze out
any excess oil before reinstalling it.
NOTE: Make sure to press the filter evenly into place to en-
sure that the foam is fully seated into its sealed position.
4. Reconnect the air filter cover and secure it with the screw.
5. Reconnect the side panel, securing with the four screws.
FUEL TANK STRAINER
Cleaning / Replacing:
1. Remove the fuel tank cap and strainer. SEE FIGURE 9
2. Clean the strainer with solvent. If damaged, replace.
3. Wipe the strainer and reinsert it.
NOTE: Make sure the tank cap is tightened securely.
SPARK ARRESTER
Cleaning / Replacing:
1. Remove the muffler shroud. SEE FIGURE 10
2. Remove muffler clamp using a flathead screwdriver to re-
move the spark arrester.
4. Remove the carbon deposits on the spark arrester using a
wire brush. If damaged, replace.
5. Reinstall the spark arrester.
6. Reinstall the muffler shroud.
SPARK PLUG
The recommended spark plug is a
maintenance and care of the spark plug go online to www.
getearthquake.com for instructions or call Earthquake
customer service.
CARBURETOR
Never tamper with factory setting of the carburetor.
Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5
. For
CMR6A (TORCH)
800 Watt Inverter Generator
WARNING
ALWAYS BE SURE THE TANK CAP IS TIGHTENED SE-
CURELY TO PREVENT FUEL SPILLS.
THE ENGINE AND MUFFLER WILL BE VERY HOT AFTER
THE ENGINE HAS BEEN RUNNING. ALLOW ENGINE TO
COOL BEFORE CLEANING/REPLACING PARTS.
AVOID TOUCHING THE ENGINE OR MUFFLER WHILE
THEY ARE STILL HOT WITH ANY PART OF YOUR BODY
OR CLOTHING DURING INSPECTION OR REPAIR.
air lter cover
air lter
side panel
mu er
clamp
spark
arrester
mu er
shroud
Operator's Manual
FIGURE 8
fuel tank cap
fuel tank strainer
FIGURE 9
FIGURE 10
17