Publicité
You've purchased a heater from North America's oldest
manufacturer of wood burning products.
By heating with wood you're helping to CONSERVE
ENERGY!
Wood is our only Renewable Energy Resource. Please do
your part to preserve our wood supply. Plant at least one
tree each year. Future generations will thank you.
This manual describes the installation and operation of the
United States Stove Company Model 2016EB woodheater.
This heater meets the 2015 U.S. Environmental Protection
Agency's crib wood emission limits for woodheaters sold
after May 15, 2015. Under specific EPA test conditions
burning Douglas Fir dimensional lumber this heater has
been shown to deliver heat at a rate of 35,750 Btu/hr. This
heater achieved a particulate emissions rate of 3.7 g/hr
when tested to method ASTM E2780-10 single Burn Rate
Appendix (*and an efficiency of 66.6%.)
This wood heater has a manufacturer-set minimum low
DO NOT BURN:
•
Residential or commercial garbage;
•
Lawn clippings or yard waste;
•
Materials containing rubber, including tires;
•
Materials containing plastic;
•
Waste petroleum products, paints or paint thinners, or
asphalt products;
•
Materials containing asbestos;
•
Construction or demolition debris;
•
Paper
products,
particleboard. The prohibition against burning these
materials does not prohibit the use of fire starters
made from paper, cardboard, saw dust, wax and
• Pencil
• 6 Foot Folding Rule or Tape Measure
• Drill, Hand or Electric
• Drill Bit 1/8" Dia. (For Sheet Metal Screws)
• 5/16" Nut Driver or 5/16" Socket w/Ratchet
• Screw Driver (Blade-Type)
• Gloves
• Safety Glasses
(FRONT VIEW)
CONGRATULATIONS!
cardboard,
plywood,
Tools and Materials Needed
TOOLS
(TOP VIEW)
burn rate that must not be altered. It is against federal
regulations to alter this setting or otherwise operate this
wood heater in a manner inconsistent with operating
instructions in this manual.
The operation of this wood heater in a manner inconsistent
with the owner's manual will void you warranty and is also
against federal regulations.
This heater is designed to burn natural wood only. Higher
efficiencies and lower emissions generally result when
burning air dried seasoned hardwoods, as compared to
softwoods or to green or freshly cut hardwoods. Burning the
following materials may result in release of toxic fumes or
render the heater ineffective and cause smoke.
This wood heater needs periodic inspection and repair
for proper operation. It is against federal regulations to
operate this wood heater in a manner inconsistent with
operating instructions in this manual.
similar substances for the purpose of starting a fire in
unaffected wood heater.
•
Railroad ties or pressure-treated wood;
•
Manure or animal remains;
•
Salt water driftwood or other previously salt water
saturated materials;
•
Unseasoned wood;
•
Any materials that are not included in the warranty
or
and owner's manual for the subject wood heater; or
•
Any materials that were not included in the certification
tests for the subject wood heater.
• 6" Pipe, 6" Elbow, Collar and Thimble; As Required (24
gauge min.)
• 1/2" Sheet Metal Screws (No. 10A x 1/2")
• 6" Inside Diameter Underwriters Laboratories (UL) Listed
Residential Solid Fuel Factory-Built Triple wall Chimney
or Exiting Masonry Chimney.
• Floor Protector Material As Specified in this manual.
• Furnace
Cement
Rutland Black Code 78 or Equivalent)
MATERIALS
(Manufacturer
Recommends:
(SIDE VIEW)
Publicité
