IARP GLOBO RETRO Instructions Pour L'utilisateur page 18

Modello - Modèle - Model
Modell - Modelo
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante
6. TRANSPORTATION
The display cabinet is contained in a specially crated package that enables transportation by the use of fork-lift trucks. Handle the
machine on its own pallet or on a similar platform; use a fork lift, either manual or electric, provided it is adequate for handling such
appliances and it has the requisite lifting capacity.
Handling is reserved to the authorised after-sales service.
The equipment MUST be kept vertical.
7. STORAGE AND
DISMANTLING
WARNING! Use protective gloves during
unpacking and installation operations.
During unloading and movement operations, avoid tilting
the machine and avoid sudden manoeuvres. The unit is
shipped anchored onto a wooden base and protected by
corner posts, cardboard top and nylon wrapping. Keep
all packaging away from children. For each subsequent
handling of the cabinet, the use of the wooden platform is
recommended.
Carefully remove the packaging, taking care not to damage
the components and not to throw away those that will be
needed for assembly.
ATTENTION! After unpacking, check that the
appliance has not suffered damage during
transportation.
The appliance, equipped or not with its packaging, must be carefully stored inside warehouses or
premises protected from bad weather, atmospheric agents and direct exposure to sunlight at a
temperature between 0 and +40 °C.
8. CHOICE OF THE INSTALLATION SITE
In selecting the place of installation, ensure that the following instructions are observed, this being vital for proper and troublefree
working of the cabinet:
• Do not install the cabinet in the vicinity of heating radiators or other heat sources.
• Do not install the cabint where it is exposed to direct sun light (e.g. through windows).
• Do not expose the refrigeration unit to air currents from fans, open doors, conditioning units.
• Keep the air intake and outlet area around the plinth area of the cabinet clear of cartons and other obstacles.
• It is necessary taht the condensing unit obtains a good circulation of air around it; also the area around the condensing unit should
not be obstructed by boxes or other objects; keep a distance from the wall of 10 cm. at least.
9. PROLONGED SWITCH OFF
When the unit is kept unused for a long time, please take note of the following procedures:
• Unplug the unit;
• Clean and dry well the tank;
• Cover the unit with a curtain, place it in a dry room and sheltered from the atmospheric agents.
GLOBO RETRO'
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
1 8 / 6 4
PAGE
N° DOC
CARDBOARD COVER
Air-Condition
UM000550
POLYSTYRENE
CORNERS
WOODEN BASE