Techno Dryer DIS-01 Manuel D'utilisation page 10

1
4
7
Installation Instruction
A1) Use the security key to open the dispenser cover.
A2) Remove the refillable plastic container.
A3) Mark wall anchors by the body of machine on the wall.
A4) Drill Φ6x30mm and insert anchors in the wall.
A5) Fix with 4 screws and hang the machine on the wall.
A6) Install batteries or connect the 6V power supply (optional).
A7) Lean the plastic container slightly, install back following the two arrows and push
the plastic container locked by the buckles.
A8) Fill in the suitable content.
A9) Close the cover and remove the key, attach the drip tray to the dispenser.
Please, ensure the nozzle of plastic container bottom installed into the nozzle
connector completely, to avoid the content leakage.
The dispenser should spout few times for normal operation after refilled new content.
Wall Installation
2
5
8
IMPORTANT WARNING:
3
6
9