Fan Assembly. Pgs - Craftsman ELLINGTON Penbrooke PNB52AO5 Guide D'installation

5. Fan Assembly (with downrod). (cont.)
With the hanging bracket secured to the outlet box and
able to support the fan, you are now ready to hang your
fan. Grab the fan firmly with two hands. Slide downrod
through opening in hanging bracket and let hanging ball
rest on the hanging bracket. Turn the hanging ball slot
until it lines up with the hanging bracket tab.
WARNING: Failure to align slot in hanging ball with tab in
hanging bracket may result in serious injury or death.
Tip: Seek the help of another person to hold the
stepladder in place and to help lift the fan up to you once
you are set on the ladder.
Find a secure attachment point (wood ceiling joist highly
recommended) and secure safety cable. It will be
necessary to use a heavy duty wood screw, washer and
lock washer (not supplied) with the safety cable loop. If
necessary, adjust the loop at the end of the safety cable.
The loop at the end of the safety cable should just fit over
the threads on the wood screw. Test safety cable by pulling
with pliers on loose end of safety cable. If the safety cable
slips, the loop must be adjusted tighter. Extra cable slack
can be left in ceiling area.
6. Fan Assembly (flushmount).
Remove and set aside canopy cover to
reveal 6 holes. Notice that 3 of these holes
are larger than the rest of them.
If there are only 3 screws in top of motor
housing, please proceed to next paragraph.
If there are 6 screws in top of motor housing,
remove every other screw and lock washer.
Remove pin, clip and set screws from motor
housing yoke. Thread wiring and safety
cable through canopy. Place canopy over
yoke, aligning larger holes in canopy with
the 3 existing screws in top of motor
housing. Insert the 3 screws and 3 lock
washers that were removed (if there were
only 3 screws located in top of motor
housing, these screws/lock washers will be
located in one of the hardware packs) into
the remaining holes. Securely tighten these
screws.
To prepare the fan for wiring, hang fan onto
hanging bracket by sliding the canopy over
the hanging bracket tab. (Use one of the
non-slotted holes on the rim of the canopy
to do so.)
set screw
clip
canopy
page 5
wood
ceiling
joist
safety cable loop
safety cable
hanging bracket tab
hanging ball slot
motor housing
canopy
canopy cover
canopy
yoke
motor
housing
hanging
bracket tab
motor housing
(top)
wood screw
and washer
pin