Testing Your Fan - Craftsman ELLINGTON Penbrooke PNB52AO5 Guide D'installation

11. Testing Your Fan.

It is recommended that you test fan before
finalizing installation. Restore power from
circuit box and light switch (if applicable).
Test fan speeds with the pull chain on the
switch housing. Start at the OFF position
(no blade movement). First pull will set the
fan to HI. Second pull will set the fan to
MEDIUM. Third pull will set the fan to LOW.
Fourth pull will again set the fan to the OFF
setting. Test light with the pull chain in the
middle. (diagram 1) If fan and/or light do
(does) not function, please refer to
"Troubleshooting" section to solve any
issues before contacting Customer Service.
Turn fan completely off before moving the
reverse switch (located on the swtich
housing). Set reverse switch to recirculate
air depending on the season:
- LEFT position in summer
(diagram 2)
- RIGHT position in winter
(diagram 3)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower
your thermostat setting in winter without
feeling a difference in your comfort.
Important: Reverse switch must be set
either completely LEFT or completely RIGHT
for fan to function. If the reverse switch is
set in the middle position (diagram 4), fan
will not operate.
Attach pull chain extension(s) supplied
or custom pull chain extension(s)
(sold separately) to end(s) of the pull
chain(s).
switch
housing
light pull
chain extension
diagram 1
diagram 2
page 9
fan pull
chain extension
diagram 3 diagram 4
reverse
switch