Vetus P6 Instructions D'installation page 3

Switch panel P6/ P12
Introduction
Each separate group on the Vetus Switch Panel P6/P12 is pro-
tected by an automatic fuse (P ..CB..) or a glass fuse (P ..F..).
The circuits are rated for maximum 10-A.
LED-lamps (light emitting diodes) indicate which circuit is ener-
gized.
Take care that the on-board voltage is the same as that stated
on the switch panel (12 or 24 Volts).
Overload
In case of an overload condition the consumers of that circuit
will be switched off and the LED will go out.
The group concerned can be switched on again as follows:
Switch Panel with automatic fuses:
- Turn the switch to the OFF position,
- Resolve the overload problem,
- Depress the protruding thermal protection button,
- Switch back to the ON position.
Switch Panel with glass fuses:
- Turn the switch to the OFF position,
- Resolve the overload problem,
- Replace the blown glass fuse (10 Amp),
- Switch back to the ON position.
Installation
Mount the panel into a position that allows the user easy acces
to the switches and a good view at the LEDs.
Depth behind fascia: 50 mm.
The splash-proof panel is intended for indoor use only.
Using the template provided, cut out an opening in the instru-
ment panel of bulkhead, see drawing 1.
Fit the switch panel with the 4 screws provided.
High currents through wiring that is too thin, or resistance
caused by poor connections, can generate heat and could
cause a fire.
Connect the plus connector (+) and the minus connector (-)
using wires with a suitable cross-section (see drawing 2):
- The plus (+) wire should be at least 4 mm
- The minus (-) wire should be at least 2.5 mm
Connect the various equipment to be operated (consumers
such as lighting, pumps, etc.) with wires with a sufficient cross-
section; minimum 2.5 mm
Detach the required name plates from the sheet and attach
them to the switch panel.
3
WARNING
2
(14 AWG).
ENGLISH
2
.
2
.
090503.03