Campbell Hausfeld CE2000 Serie Manuel D'utilisation Et Liste De Pièces page 9

Maintenance (Continued)
dRive belt
Belt stretch is a result of normal use� When properly adjusted, the belt deflects about
1/2 inch with five pounds of pressure applied midway between the engine pulley and
pump�
To adjust drive belt tension:
1� Remove belt guard and loosen engine brace�
2� Loosen the four fasteners holding the engine to the baseplate�
3� Shift the engine in the proper direction� The belt must be properly aligned when
adjustment is made�
4� To align belt, lay a straight edge against the face of the flywheel, touching the rim at
two places�
5� Adjust flywheel or engine pulley so that the belt runs parallel to the straight edge�
6� Use a gear puller to move the pulley on the shaft and tighten fasteners�
7� Adjust brace and reinstall belt guard�
stoRaGe
1� When not in use, hose and compressor should be stored in a cool, dry place�
2� Tanks should be drained of moisture�
3� Hose should be disconnected and hung with open ends down to allow any moisture
to drain�
Series CE2000
1/2 inch Deflection
figure 10
Belt
figure 11
www.chpower.com
Straight
edge
Touch Rim
of Flywheel
in Two
Places
9