Important Use And Safety Notes; Product Dimensions - concept 2 BikeERG Manuel Du Produit

Important Use and Safety Notes

• All fasteners must be fully tightened. Check for
tightness according to the Maintenance section
(page 6).
• Do not stand the BikeErg up on end as the BikeErg
may tip over.
• Use of this machine with a worn or weakened part
may result in injury to the user. When in doubt
about the condition of any part, Concept2 strongly
advises that you replace the part immediately. Use
only genuine Concept2 replacement parts. Use of
other replacement parts may result in injury or poor
performance of the machine.
• The machine should be used on a stable, level
surface. The BikeErg should be approximately level.
The rear foot has leveling pads that can be adjusted
as needed.
• To move the BikeErg, pick it up by grasping the rear
foot and lift until the caster wheels start to roll.
• Keep children, pets and fingers away from pedals.
Pedals can cause injury.
• Perform proper maintenance as described in the
Maintenance section (page 6).

Product Dimensions

WEIGHT CAPACITY
300 lb
136 kg
MACHINE DIMENSIONS
24 in x 48 in
61 cm x 122 cm
TRAINING AREA
48 in x 60 in
122 cm x 152 cm
ENGLISH
FREE AREA
72 in x 84 in
183 cm x 213 cm
3