Axia Q60-S Serie Guide D'installation page 27

11. Make sure the clamp is in place, insert the braided shield coil into the ground clip and
tighten the screws.
NO TICE TICE
NO NO TICE
• The shields and the clamp surfaces shall be in full contact with each other so that the
multi-connector cable is grounded.
• Make sure that the multi-connector cable jacket is firmly secured by the clamp.
• Make sure all surfaces and contacts are clean and free from scrap shield material.
12. Connect the network cables to the external network connectors (RJ45, SFP) as required.
Note
An SFP module (not included) has to be used when connecting an optical fiber cable.
7
6
5
1
Power cable (DC input)
2
Power connector (DC input)
3
Network connector SFP (external) (2x)
4
Network connector RJ45 (external) (2x)
5
I/O connector (external)
6
Multi-connector cable IP66
Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com
AXIS Q60-S Series
8
1
2
4
27
3