Publicité
Les langues disponibles
Les langues disponibles
4
NL EN
DE
FR
− In the event of a power cut, the positions in the motor unit will be maintained.
− If the system/curtain is moved without power supplied/during a power cut, it will lose its
!
reference positions and the system end positions will need to be re-entered.
Adding/removing curtain positions
In order to change or add curtain positions in a system, you must repeat the above steps 1 to 6
of "programming curtain positions" for that system.
Changing button functions for opening and closing
Repeat the procedure "programming curtain positions" wereby the opposite buttons for opening
and closing the curtain are selected.
For several linked systems: Remember that changing the "open" and "close" positions will
!
have consequences for any central control of linked systems: for example, a central "close"
command will result in the system being operated.
STEP 1
Use the remote control (Open/Close buttons) to ensure a distance of 20
cm (8 inch) or more between the overlap carrier and the end pulleys.
STEP 2
Using the transmitter, keep the stop button pressed: a
green led will start flashing in the bottom of the motor unit,
release the button only when the LED flashes red (after
approx.8 seconds). The system overlap carrier will move
briefly in both directions.
STEP 3
Press CLOSE* on the transmitter and release it when the curtain reaches
the desired position. Briefly pulse OPEN or CLOSE for further fine
adjustment.
* The button you choose here, either open or close, will represent the
close function.
STEP 4
Briefly press stop to confirm the position. The system will move briefly in
the "open" direction.
STEP 5
Press OPEN ** and keep it pressed until the curtain reaches the desired
position. Briefly pulse OPEN or CLOSE for further fine adjustment.
** Press CLOSE if reversed button function was chosen in step 3.
STEP 6
Briefly press stop to confirm the position. The system will move a short
distance in the "close" direction.
The red LED on the bottom of the motor unit goes out. The positions are
set and the rail is ready for use.
Gama modułów-nadajników NiceWay
Gama modułów-nadajników NiceWay
Gama modułów-nadajników NiceWay
Gama modułów-nadajników NiceWay
Gama modułów-nadajników NiceWay
Publicité
