SilverCrest SGKT 50 A1 Manuel D'utilisation page 169

Base - Everyday use
Making calls
External calls
Use the numeric buttons [24] to enter a telephone number. After you have entered the phone
number, pick up the receiver to call the entered number.
Press the
You can adjust the receiver volume during a call by pressing the
reduce the volume or the
shown on the display [17].
You can also pick up the receiver first and dial the number afterwards using the numeric buttons
[24]. Please note that in this case the entered phone number is dialled immediately.
Calling a number from the phonebook
If you want to use a number stored in the phone book, press the Phonebook button [19] while in
standby mode. Press the  or  multifunction control buttons [16] to select the desired entry and
then pick up the receiver to call the selected entry.
Put down the receiver to end the call.
You can also pick up the receiver first and then dial the number from the phonebook. To do this,
press the Phonebook button [19] and then use the  or  multifunction control buttons [16] to
select the desired entry. Next press the Menu/OK button [15] to confirm your selection. Press the
 or  multifunction control buttons [16] to select the "DIAL NUMBER" menu item and then press
the Menu/OK button [15] to call the selected entry.
For more information about adding a new phone book entry, please read the
chapter "PHONEBOOK" on page 156.
button [26] to clear the entered digit.
button [28] to increase it. The current volume level is
SilverCrest SGKT 50 A1
button [27] to
English - 167