Publicité
Les langues disponibles
Les langues disponibles
Level
0
1
2
In the LEVEL 2 state, this lamp blinks for 3 hours after the completion of the cycle. (If the wrinkle
prevention function is activated, this message is displayed for up to 3 hours.)
If the power button is pressed or the door is opened, the power is immediately turned off.
For more information about the duct installation, please refer to the "Ducting requirements"
section on page 8.
• Although the dryer is available even if the blockage message is displayed, the drying time
• If the LEVEL 1 message is displayed the first time the dryer is run after the installation,
DV9100HA-DC68-03170K-12-EN.indd 29
Message
The "Vent Sensor
lamp is turned off.
The "Vent Sensor
lamp illuminates.
The "Vent Sensor
lamp blinks.
may be extended.
check the connection and clean the duct. If the LEVEL 1 message appears even
after you have checked and cleaned the ducts, this may indicate that there are some
restrictions of the duct due to the length, condition, etc.
If this occurs, you can use the dryer normally and no countermeasures need to be taken.
However, the drying time may be extended or the drying performance may be degraded.
Status
The ductwork is free from
"
blockages.
When a part of the duct or
the lint filter is blocked by lint
or a foreign object.
"
When the resistance is high
because the duct is too long
or bent.
When the duct is blocked by
lint or a foreign object.
"
When the resistance is very
high because the duct is too
long or bent excessively.
English - 29
Solution
-
Check the duct
connection and shorten
the duct and straighten it
if necessary.
Check the lint filter or
the duct and clean it if
necessary.
Check the duct
connection and shorten
the duct and straighten it
if necessary.
Check the lint filter or the
duct and clean it as soon
as possible.
2018/11/19 14:14:37
Publicité
