Omega Wheel Arm 92100 Manuel D'utilisation Et Liste De Pièces page 3

Assembly
1. Raise 2-Post Lift up to a workable height.
2. Place the Rear Plate on the top interior side of the 2-Post Lift beam.
3. Place the Bottom Plate underneath the 2-Post Lift beam and between the Rear Plate; attach using 2 of the
M8 x 1.25 x 12 Socket Head Screws. (refer to Fig. 2)
4. Put the Front Plate on top of the Rear Plate facing the opposite direction, and attach using 2 of the M8 X 1.25 X 14 Socket
Head Screws. (refer to Fig. 3)
5. While holding the Support Arm against the front supports of the Front Plate, place the Ball Support underneath
the Support Arm and attach using 2 of the M8 x 1.25 x 12 Socket Head Screws. (refer to Fig. 4)
Figure 4: Attaching Ball Support and Support Arm to Front Plate.
Figure 2: Attaching Bottom Plate to the Rear Plate.
Figure 3: Attaching Front Plate to the Rear Plate.
3