Publicité
Les langues disponibles
Les langues disponibles
5
l.
After the Rod is cut, replace the Body of the
bracket on top of the Rod and secure it in place
with the Knob.
NOTE:
Clearance is built into the Body to fit
the top of the Rod in an imperfect cut from the
previous step.
m. To fine-tune the height of the Body, loosen the
Nylon Hex Nut at the base of the Rod. Once
loose, rotate the Rod in the Swivel Base in a
clockwise direction to lower it and in a counter
clockwise direction to raise it. Only use the
adjustment at the bottom of the Rod to fine-
tune the height of the Rod to provide adequate
support. Test the placement with the motor in
the stowed position.
n. Rotate the Rod in place until it is the proper
height to provide adequate support for the
Shaft. Then secure the Rod by rotating the
Nylon Hex Nut down until it is tight against the
Swivel Base.
6
o. To use the Bow Mount Stabilizer Bracket,
engage the Plunger and rotate the Swivel Base
so that the Rod is locked into position.
p. Rotate the Body so that the cradle aligns with
the motor Shaft. Stow the trolling motor and
lower the motor so that the Shaft is captured
in the Body of the bracket. Secure the Shaft by
hooking the Rubber Strap in place.
CAUTION
The Rubber Strap is only intended to capture the motor
Shaft. Do not constrict any wires routing out of the
Control Head, or otherwise in the Rubber Strap when it is
secured on the Bow Mount Stabilizer Bracket.
For warranty information please visit minnkotamotors.com
WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
minnkotamotors.com
Part #2374952
Minn Kota Consumer & Technical Service
Johnson Outdoors Marine Electronics, Inc.
PO Box 8129
Mankato, MN 56001
ECN 38209
5l
Rubber Strap
5n
Swivel Base
Boat Deck
121 Power Drive
Mankato, MN 56001
Phone (800) 227-6433
Fax (800) 527-4464
Body
Rod
Rod
Nylon Hex Nut
Rubber Strap
Shaft
A Johnson Outdoors Company
©2017 Johnson Outdoors Marine Electronics, Inc.
All rights reserved.
Rev B
08/17
Publicité
