Publicité
Les langues disponibles
Les langues disponibles
3
ITEM(S) NEEDED
#24 x 4
f.
Detach the Removable Base from the rest of
the bracket by sliding it apart from the Non-
removable Base. If the installation will include
the Removable Base, align it with the holes
that were drilled. If it will not be used, set it
aside and place the bracket on the deck of the
boat aligned with the drilled holes.
g. Take the four Phillips Pan Head Screws
(Item #24) and place one each in the hole of
the selected base and into the drilled holes.
Double check the orientation and then secure
to the Deck of the boat with a #2 screwdriver.
4
h. Screw the Nylon Hex Nut up to the top of the
threads on the Rod and then leave it in place.
Remove the Rod from the Swivel Base. Hold
the Rod in place next to the Swivel Base.
i.
Next stow the motor and determine how tall
the Rod on the bracket needs to be. There
are 6 notches along the top of the Rod that
are used to adjust the height of the Rod for
support. Based on the configuration for your
installation, sections may need to be removed
in order to obtain the proper support height.
One section on the Rod equals approximately
one inch.
j.
If the Rod for your installation needs to be cut
shorter, loosen the Knob at the top of the Rod
until the Body can pull free from the Rod.
k. When cutting the Rod at least one notch
on the Rod must remain. Double check the
intended position of the cut before cutting and
make sure that the Rod is not cut too short.
Once the position is selected, use a hacksaw
at one of the notches to cut the Rod to the
correct height. If the original cut is too long,
an additional section can always be cut after
testing the Rod.
4k
Rod
Do Not Cut
©2017 Johnson Outdoors Marine Electronics, Inc.
Cut Location
Notch
Section
3f
Swivel Base
Plunger
Non-
removable
Base
Removable Base
Non-
3f
removable
Base
Inboard
Boat
Deck
Marking
Drill
Holes
Drill
Holes
4h
Hold Rod as
shown for
measurement
Nylon
Rod
Hex Nut
Swivel
Base
NOTE:
When cutting the Rod at least one notch
on the Rod must remain. If unsure, leave the Rod
longer, and cut off fewer notches and test after each
notch is removed before finishing the installation,
or have the bracket installed by a qualified marine
installer.
CAUTION
When cut to the proper length and adjusted correctly
the Stabilizer body will not interfere with normal stowing
of the motor. On Terrova and PowerDrive this device is
not a substitute for positioning the Depth Collar against
the Steering Housing and tightening it to guard against
accidental deployment.
3f
Inboard
Marking
Removable
Drill Holes
Base
Boat Deck
3g
Phillips
Pan Head
Screw
Boat
Deck
Removable
Base
4i
Body
Knob
Shaft
Ideal
Control
placement
of Body
Head
Rod
Trolling Motor
fully stowed
Nylon
Boat Deck
Hex Nut
minnkotamotors.com | 3
Publicité
