Power Supply (Fig. E); Console (Fig F); Explanation Display Functions - Tunturi FitCycle 40 Manuel De L'utilisateur

English
Adjusting the vertical seat position
The vertical seat position can be adjusted by setting the
seat tube to the required position. With the leg almost
straight, the arch of the foot must touch the pedal at its
lowermost point.
- Loosen the seat tube adjustment knob.
- Move the seat tube to the required position.
- Tighten the seat tube adjustment knob.
Adjusting the handlebar
The handlebar can be adjusted according to the height
and the exercise position of the user.
- Loosen the handlebar adjustment knob.
- Move the handlebar to the required position.
- Tighten the handlebar adjustment knob.

Power supply (Fig. E)

The trainer is powered by an external power supply.
Refer to the illustration to locate the trainer power
input.
NOTE
• Connect the power supply with the trainer
before connecting it to the wall outlet.
• Always remove power cord when
• machine is not in use.

Console (fig F)

1
3
2
1. Display
2. Tablet/ book support
3. Buttons
All manuals and user guides at all-guides.com

Explanation Display functions

Time
-
-
-
-
Speed
-
-
RPM
-
-
WATTS
-
-
LOAD
-
Distance
-
-
-
2 2
CAUTION
• Keep the console away from direct sunlight.
• Dry the surface of the console when it is covered
with drops of sweat.
• Do not lean on the console.
• Only touch the display with the tip of your finger.
Make sure that your nails or sharp objects do not
touch the display.
NOTE
• The console switches to standby mode when the
equipment is not used for 4 minutes.
Without setting the target value, time will count up.
When setting the target value, time will count down
from your target time to 0 and alarm will sound or
flash.
Without any signal being transmitted into the
monitor for 4 seconds during workout, time will
STOP
Range 0:00~99:59
Displays current training speed.
Maximum speed is 99.9 KM/H or ML/H.
Without any signal being transmitted into the
monitor for 4 seconds during workout, SPEED will
display "0.0"
Displays the Rotation Per Minute.
Display range 0~15~999
Without any signal being transmitted into the
monitor for 4 seconds during workout, RPM will
display "0"
Display current workout watts.
Range 0 ~ 999
Shows tension level setting, when adjusting
resistance, for 3 seconds.
Without setting the target value, distance will count
up.
When setting the target value, distance will count
down from your target distance to 0 with an alarm
sound or flash.
Range 0.00~99.99