Ermax 0701122 Serie Notice De Montage page 4

- Disconnect the terminals indicated on the photos below :
- Remove the mirrors and the nose fairing by pulling it towards you.
- Unscrew the 4 screws securing the top of the nose fairing.
- Remove the top cover with the original screen. Unscrew the 4 screws from the screen and remove it.
- Reinstall the top cover of the nose fairing thanks to the 4 screws previously removed during
disassembly (the Aéromax screen is still not fixed at this stage).
- Replace the nose fairing on the bike. Reconnect the terminals previously removed (except the
dashboard's terminal). Place the Aéromax screen on it. Replace the side plastic rivets on the nose
fairing. Reconnect the indicators. Clip the cables and tighten the ring securing the beam.
Clip again the low fairing and screw the 2 lower screws of the fairing.
- Refit the dashboard's fitting bracket as shown on the picture.
- Present the dashboard on the bike to check the proper alignment of the mounting brackets (adjust them
if necessary). Reconnect the meter, the terminal and screw the dashboard thanks to the 4 screws
previously removed.
- Replace the side fairing with 4 plastic rivets, and then refit the mirrors.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* The mentioned label of motorbikes's manufacturers are indicated exclusively as a reference to Ermax accessories.
« CAUTION »