Publicité
Les langues disponibles
Les langues disponibles
2. Mount the transmitter with adhesive pad and press it onto the desired position for about 30 seconds
Operation:
1. Work mode
1). Turn off the main power.
2). Connect the bulb with the bulb holder and then connect with your home bulb holder.
3). Turn on the main power and the lamp switch. Then you can use the controller to turn on/off the bulb.
Note: To use the controller, the lamp switch needs to be always on.
2. Learn mode
Maximum of 3 transmitters can be learnt to a single lamp holder.
No limit to the number of lamp holders.
Specification:
Power Supply
Operation Temperature
Range (Open Field)
RF Frequency
Power Consumption
Load power
Operating Force
Learn button
Blue indicator
Receiver (Bulb holder)
AC 180V~260V（50/60HZ）
-10℃~+45℃
<750mW
150W
-
1). Long press the learn button on the lamp
holder for 5 seconds until the blue indicator
turns off.
2). Short press the transmitter twice in one minute
until the bulb is been controlled. If not, press
the transmitter again.
3.). Complete and exit the learn Mode
automatically.
Note: No operation in 1 minute, the lamp holder
will exit Learn Mode automatically.
Transmitter (controller)
Self-powered
-40℃~+45℃
70m
433MHz
-
-
<10N
GB
Publicité
