Phottix Strato II Multi Manuel D'utilisation page 4

Please Note:
Strato Multi receivers are designed
to work in Manual Exposure mode and have no TTL
functions.
Only use flashes designed for Digital SLR cameras (6V)
on the Strato Multi transmitter hot shoe when on the
camera.
Tip:
Turn off all devices – flashes/strobes, cameras, and
Phottix Strato Multi transmitters and receivers - when
connecting and disconnecting devices.
Keep in mind:
The Strato Multi will trigger Strato
4-in-1 wireless triggers. When shooting in public bear
in mind other photographers using the same products.
Inserting batteries
1. Press the battery cover in while pushing it away from
the Strato Multi transmitter or receiver. The battery cover
will snap open and slide open.
2. Remove the battery cover from the Strato Multi.
3. Insert AAA batteries.
4
4. Replace the battery cover and push back into the
locked position.
Turning transmitter and receiver on/
off
1. To turn on the Phottix Strato Multi transmitter or
receiver– move the power switch to the "ON" position.
2. To turn off the Phottix Strato Multi transmitter or
receiver - move the power switch to the "OFF" position.
Test Button
1. The Test Button will test fire flashes/strobes.
2. To Test: Press the transmitter Test Button. Flashes
connected to Phottix Strato Multi receivers on the
same channel and selected groups will fire when the
transmitter test button is pressed.
3.Pressing the receiver Test Button will test fire flashes or
strobes connected to that receiver.
For Wireless Shutter Release: See Using the Strato Multi
as a wireless shutter release below