TMC REEF-Tide 6000 Mode D'emploi page 8

REEF-Tide instructions v1-2017_Layout 1 02/06/2017 16:25 Page 8
Time/Mode Button
3.
Use this button to set the time and for accessing the wave mode settings
4. Scroll button
This button allows you to scroll right whilst changing settings
FEED Button
5.
Press "FEED" to pause pump operation for 10 minutes.
When you enter FEED Mode the LCD screen on the controller will display F010 (Feed Mode
10 minutes) and the pump will stop pumping. The controller will then start a 10 minute
countdown which will be displayed on the LCD screen of the controller, starting at F010 and
counting down in minutes to F009, F008 and so on until it displays F000, at which point the 10
minutes have elapsed and the pump will resume operation and start pumping.
If you wish to restart the pump before the end of the 10 minute pause, press FEED again and
the pump will restart.
6. Increase Button
When changing settings, this button will allow you to increase the number displayed.
SETTING THE CURRENT TIME
1. Press the Time/Mode button
The ":" will flash to indicate you are in time setting mode.
2. Using the
3. When the last number you have adjusted stops flashing the current time has been set and
saved.
FACTORY SETTINGS
The REEF-Tide/REEF-Tide Compact Controller is currently set to the following factory settings:-
Time Period
1 = Dawn (05:30-07:30 hrs)
2 = Sunrise (07:30-09:00 hrs) 4 = 100%
3 = Daylight (09:00-14:00 hrs) 4 = 100%
4 = Sunset (14:00-16:30 hrs) 4 = 100%
5 = Night (16:30-05:30 hrs)
If you wish to adjust these settings, please read the following instructions.
All manuals and user guides at all-guides.com
to enter the time setting mode.
and buttons enter the current time
Power Intensity
3 = 80%
1 = 40%
Wave Mode
2 = Surge Mode
2 = Surge Mode
1 = Pulse Mode
2 = Surge Mode
3 = Continuous Stream
5
Wave Frequency
4
3
3
5
8