Electrolux EFP 60271 Manuel D'instructions page 11

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

The hood can be switched on pushing directly onto the requested speed without firstly having to select 0/1 button.
Touch
Basic functions
control
Dual Function
When briefly pressed it switches the lighting system on
L
and off.
When pressed the motor is stopped, regardless of the
T1
speed it is set to.
When pressed the motor is set to the first speed
T2
By a brief pressing the motor is set to the second speed.
T3
By pressing the touch control for approximately 2
seconds the Delay function is enabled, i.e delayed
shutdown of the appliance ensuring a complete
elimination of the residual odours. This function can
be activated at OFF-position and at 1°, 2° and
3°speeds. It can be stopped in advance by pressing
any of the touch controls (T) with the exception of
T3. The Delay function works according to the fol-
lowing scheme:
1°speed / OFF
2°speed
3°speed
When pressed the motor is set to the third speed
T4
When pressed the motor is set to the intensive speed
T5
timed to 5 minutes. At the end of 5 minutes of inten-
sive speed the hood starts again at the speed it was
set to previously. In case the hood is set to the inten-
sive speed directly from OFF-state it will then start
from the first speed after 5 minutes of intensive
speed.
When pressed for 4 seconds it resets the filter alarm
F
signal indicated by flashing of the touch control T1. This
procedure can be carried out only when the motor is
stopped.
EN
= 20 minuets
= 15 minutes
= 5 minutes
Indicator lights
Touch control
Lights off
unlit
Touch control lit
Motor on
Touch control
Motor off
unlit
Touch control lit
Touch control lit
Second speed on
Flashing touch
Delay function on
control
Touch control lit
Touch control lit
Touch control lit
Metal grease filters
saturation alarm. Metal
grease filters need to
be washed. The alarm
starts up after 100
working hours.
Flashing touch
Charcoal odour filter
control
saturation alarm. Char-
coal filter has to be
replaced and metal
grease filters washed.
The alarm starts up
after 200 working
hours. (Activation;
check the paragraph
"Odour
filter")
1
11
1

Publicité

Table des Matières
loading

Table des Matières