Operation; Commissioning; Menu Settings - Renkforce DB-L6F Mode D'emploi

10. Operation

Always pull the mains plug before filling the fog machine.
Never fill the fog machine with flammable liquids or add such to the fog liquid. Only ever use
suitable water-based fog liquids (the CONRAD range features suitable fog liquids, see „Techni-
cal Data").
Never tilt the fog machine. Fog liquid may leak out or enter the inside of the device and cause
damage there or injure the operator.
Make sure that no liquid enters the inside of the device when you are filling it with fog liquid.
This may cause damage to the device and potentially fatal electrical shock.
DMX operation always takes precedence over manual operation. Once a DMX signal is pen-
ding, manual operation is deactivated.
a) Commissioning
• Ensure that the mains plug is not plugged in.
• Unscrew the tank cover from the device and fill fog liquid into the tank. Observe that the tank is not over-
filled, depending on the desired operating position (horizontal or vertical). Top up the tank in the same
position in which you want to operate the fog machine later.
• Then screw on the tank closure lid again.
• Plug the connection plug of the remote control into the WIRE CONTROLLER (5) port at the rear of the fog
machine.
• Plug the mains plug into a mains socket with a protective ground contact.
• Switch on the device with the mains switch (1). With the device on, the mains switch lights up and the
fog machine heats up.
• Heating up takes approx. 3-4 minutes. During this process, the display (2) indicates UP.
• When the device has reached operating temperature, the display (2) shows reAd and the device is ready
to produce fog. Additionally, the LED displays at the wired remote control will light up when the device is
ready to produce fog.
b) Menu Settings
The menu settings are made via the display and the function buttons FUNC,
• Push the button FUNC to get to the menu and select the desired menu item. The menu items can be
selected with the buttons
• Push the button ENTER and set the desired menu option with the buttons
• Press the ENTER button to confirm your selection.
and as well.
, and ENTER.
and .
31