Technical Specifications; Installation; Electrical Connection; Installation Into 1.5'' Standard Wall Conduit / Nozzle - ccei Mini Brio + Notice Technique

Technical information sheet

2. Technical specifications

Dimensions

Installation

Power supply
Power consumption
Max. luminous flux
LED type
Protection rating
3. Installation

3.1. Electrical connection

Installation of this project involves a hazard of electric shocks. We strongly recommend you
contract a professional installer. An installation error can put you in danger and may irre-
versibly damage the product and the equipment connected to it.In compliance with the NF C
15-100 standard, pool lights installed in Volume 0 must always be powered by VLSV (Very low
safety voltage). Always cut off the power upstream before handling the electrical installation.
Risk of electric shock. Only connect to a circuit which is protected by a ground fault circuit
breaker . If you are not sure if these types of device are fitted, contact a qualified electrician.

3.2. Installation into 1.5'' standard wall conduit / nozzle

In case of installation into 1.5'' other brand nozzle, you can screw your light into the nozzle. For customization, you can use the
supplied cover with nozzle or install a Mini-BRiO 2 specific bezel (see catalog).
WARNING : in case of installation with Mini-BRiO 2 bezel, it is necessary to pass the wall through the bezel before screwing.
Reverse is impossible.
Mini Brio + & Switch M7 & X8
In a 2" brush socket (with trim PF10R294)
In a CCEI crossing PF10R291 (shell) or PF10R292 (liner)
Voltage: 12 V ~ (AC) / Frequency: 50Hz/60Hz
8W (Version X8 RGB) - 450 lm (depending on the colour)
PK10R314 (M7 +)
PF11R321 (M7 Switch)
PK10R315 (MK7 +)
PF11R322 (M7K Swtich)
PK10R313 (X8)
9 Power LEDs monochrome (3R/3G/3B)
PK10R323 (X8 Switch)
Risk group 1 (low risk) as per IEC62471:2006
The electrical connection must be performed dry, in a sealed
connection box whose cable glands must be tightened in order
to avoid any water infiltration.
Ø 49mm / depth 63mm
In a standard 1.5" brush socket
7W (Version M7) - 700 lm
3 Power LEDs Cold white (~6000°K)
3 Mid Power LEDs Warm white
(~3000°K)
v1.0EN
IP-68
2