Publicité
Les langues disponibles
Les langues disponibles
Press the ON/OFF BUTTON (A) to turn on heater, then press MODE (B) to your desired power setting
•
(FAN, LO, or HI). The LED light (C) will illuminate and turn to different colors to show different settings.
The power settings operate as follows:
Blue for fan only
Orange for low heat setting
Red for high heat setting
NOTE: When the unit is turned off, the fan will continue to run for around 15 seconds to cool down.
CAUTION: This heater includes a thermal cut-off overheat protection system that shuts the heater off if it
overheats due to abnormal conditions. If this occurs, turn the heater "OFF", unplug it, and inspect and remove
any objects on or adjacent to the heater. Allow it to cool for a few minutes, plug it back in, and resume normal
operation.
TROUBLESHOOTING
If your heater fails to operate, please follow these instructions:
•
Ensure that your circuit breaker or fuse is working properly.
•
Be sure the heater is plugged in and that the electrical outlet is working properly.
•
Check for any obstruction. If you find any obstruction, turn the heater "OFF". Unplug the heater and wait a few
minutes for it to cool down. Carefully remove the obstruction. Plug the heater in and turn it on again by
referring to the OPERATING INSTRUCTIONS.
NOTE: IF YOU EXPERIENCE A PROBLEM WITH YOUR HEATER, PLEASE SEE THE WARRANTY
INFORMATION FOR INSTRUCTIONS. PLEASE DO NOT ATTEMPT TO OPEN OR REPAIR THE
HEATER YOURSELF. DOING SO MAY VOID THE WARRANTY AND COULD CAUSE DAMAGE OR
PERSONAL INJURY. IF THE PROBLEM STILL PERSISTS, PLEASE CONTACT US BY REFERRING
TO THE SERVICE & SUPPORT INFORMATION ON THE FOLLOWING PAGE.
CLEANING AND STORAGE
It is recommended that the heater be cleaned at least once during the operating season in order to provide the
optimum level of performance. ALWAYS TURN THE POWER SWITCH OFF AND UNPLUG THE HEATER
BEFORE CLEANING. Be sure to save the box for off-season storage.
Turn the heater "OFF", unplug it and wait for the heater to cool down.
•
•
Use a dry cloth to clean only external surfaces of the heater.
•
Do not use any cleaning agents or detergents.
•
Never immerse the heater in water.
•
Pack the heater in the original carton and store it in a cool and dry place.
SPECIFICATIONS
Model No.: LLR84162
Voltage: 120V AC, 60Hz
Current: Maximum continuous draw = 12.5 Amps
Output: 5200 BTUs
Power: LOW = 900 Watts, HIGH = 1500 Watts
Tolerances on all specifications: not exceeded than 105%.
3
Publicité
