Maintenance; Storage - Maruyama MS0835W Manuel D'utilisation

For cleaning, check and maintenance, always be sure to stop machine.
Check and maintenance items for each season
Cleaning of air cleaner
● When elements become dirty or clogged, reduced performance
or difficulty starting is observed. Clean the elements regularly
to remove dirt and prevent clogging.
● When cleaning the element, wash it using gasoline, dip it in
the blended fuel used and install it after squeezing it hard to
remove excess fuel.
Disassembly
1
Element
Cover
Clean
2
3 Squeeze
Squeeze
hard
Cleaning ignition plug
● Remove carbon, and adjust the clearance to 0.6-0.7mm.
0.6~0.7mm
CAUTION
Don't leave chemicals in the chemical tank and pump. This might cause the machine to break down.
1 Remove fuel from fuel tank, and operate the machine in
idling state until it stops.
2 Set pressure control valve handle to "STARTING".
CAUTION
● When damage is found, store it after making repairs. In this case, use the genuine parts specified by us for all parts and
consumable goods.
● Keep in a place free of moisture, dust and dirt.

Maintenance

Cleaning, maintenance and draining
Gasoline
Dip in the
blended fuel
Remove
carbon

Storage

Check for worn piston packing and seal packing, and replace
worn one with new one.
※ For disassembly and maintenance, consult with the sales
outlet where you purchased the product or sales office.
CAUTION
Make sure to drain, otherwise the pump might be damaged by
freezing in winter.
① Remove drain cap of chemical tank and hose connecting screw
of pump to drain residual liquid.
② Put fresh water into the chemical tank, start the engine, spray
from the nozzle to clean the pump and inside of the hose.
③ Operate for 15-20 seconds to drain residual liquid at the
throttle lever position, which is a little bit back from full open
position.
④ Set throttle lever at low speed, and stop the engine with the
stop button.
3 Move throttle lever to low-speed position.
4 After finishing the above, put the machine in a box and
store it at a place free from moisture and which is well
ventilated.
Pump
Drain
Hose contacting
screw
Drain cap
6