Publicité
Les langues disponibles
Les langues disponibles
• Remove the plastic plug from the measurement tube.
• Put the sensor in place.
• Place the panel in the intermediate position.
• Switch on the boiler.
• Place the screwdriver on setting position and hold it
there.
• Bring the boiler up to maximum power:
- Open the control panel flap, simultaneously
press buttons
seconds and set the burner power using buttons
+ and -.
: Maximum output.
• Measure the smoke content in CO
measuring equipment.
• Set the gas flow using the screwdriver by moving the
adjustment screw until the required CO
obtained.
Unscrew to increase CO
• Check the CO
content in the smoke.
2
• Once correctly adjusted, place the general switch on
"0".
• Remove the measuring equipment. Replace the
plastic plug onto the measuring tube.
•
Fit the unit together.
and
for about 2
using the
2
content is
2
, screw in to decrease CO
2
Modus operandi
Seen from the left
Natural gas H
Natural gas L
.
Butane/Propane
2
6
.
CO
2
content (%)
9,0
8,8
10,5
Publicité
