Publicité
Les langues disponibles
Les langues disponibles
EN | SYNC by 50 On-Ear with Bluetooth®
Refer to this guide for button descriptions and
locations of other features mentioned throughout
the manual.
ON BOARD CONTROLS
1
2
3
4
5
6
RIGHT EARCUP
SIDE
Button Locations & Descriptions
EARCUP BOTTOMS
3.5mm
Micro USB
Audio Jack
Port
AUDIO CABLE
Microphone
Call Answer /
Audio Control button
*The audio/mic cable is compatible with
iPod
, iPhone
®
On/Off & Pairing Mode
FOLDING YOUR
Volume Up
HEADPHONES
Play/Pause & Answer/End
Track Forward
Track Back
Volume Down
Remove cable.
Audio Cable
Fold one side then the other.
Getting Started
Powering On/Off:
To turn on: push power/pairing switch to center position. A tone will
sound indicating the power is on and LED light will begin to blink.
To turn off: push power/pairing switch to off position. LED light will
stop blinking.
Connecting Your Device:
1. Make sure your device is in Bluetooth® discovery mode.
2. When power is on and LED light is blinking, pull down and hold the
power/pairing switch in the SYNC position for approximately 3 seconds.
and iPad
.
™
™
The LED will begin to flash rapidly.
3. Release the power/pairing into the center position and choose 'SYNC
by 50' on your pairing device (New phones will connect automatically –
some phones may require password '0000' to be entered).
4. Once connected, the next time the SYNC by 50 On-Ear Bluetooth®
headphone is turned on, it will automatically connect to your device.
EN | SYNC by 50 On-Ear with Bluetooth®
Publicité
