Publicité
Les langues disponibles
Les langues disponibles
ENG
IMPORTANT
Before using the device, carefully read the instructions.
Keep this manual for future reference: it includes important safety recommendations for
the use and maintenance of the device.
SUITABLE FOR INDOOR AND OUTDOOR: THE DEVICE MUST BE PROTECTED
AGAINST RAIN AND ELEMENTS.
PACK CONTENTS
MOSQUIT ALL
- User Manual
- Power supply input 110-240 Volt 50-60Hz 0,4 A; Output 12 Volt 0,6 A
ATTENTION: The power supply is situated inside the attractant door compartment.
OPERATING PRINCIPLE
Mosquito and other insect females feeding on blood bite to obtain the proteins they
need for their eggs to mature. They fly around to find the hosts to bite following visual
stimuli such as light and olfactory contrasts: carbon dioxide and the odours released by
the human body through breathing and sweating.
Through the combination of all these stimuli, Sandokan MOSQUIT ALL, with its new
Leds and fan used, attracts the insects inside the action area of its fan, sucking them
inside the special compartment, where they soon die due to dehydration.
The outer grid selects only the blood sucking insects and it is calibrated to minimize the
inlet of other useful insects into the cone of intake.
We recommend installing the device in early spring so as to minimize the number of
mosquitos when their population is still small.
SANDOKAN ATTRACTANT INSTALLATION
MOSQUIT ALL doesn't make use of insecticides, pesticides, repellents, essential oils,
antimosquito spirals or candles. It does not make use of hazardous chemical products
or possibly hazardous products to the human body or to the environment.
MOSQUIT ALL can be used in combination with Sandokan attractants containing octe-
nol, carboxylic acids and other molecules present in the normal metabolism of humans
and animals.
This device makes use of the most environmentally-friendly methods available on the
market, and is completely safe for you and the environment.
INSTALLATION:
(Part No. 7355, Part No. 7356)
- Before carrying out any maintenance operation, disconnect the device from power
mains (Fig. 1 - 2).
- Open the top cap of MOSQUIT ALL, by lifting the cover delicately with two hands (Fig.
3 - 4):
- Insert the attractant; If cap (part. No. 7355) is used, make sure that holes are pointing up.
Publicité
